Red Hat ENTERPRISE LINUX 5 - Page 27

Cluster Configuration File with IPMI Fence Device
17
<fence_daemon clean_start="0" post_fail_delay="0"
post_join_delay="3"/>
<clusternodes>
<clusternode name="clusternode1.example.com" nodeid="1"
votes="1">
<fence/>
</clusternode>
<clusternode name="clusternode2.example.com" nodeid="2"
votes="1">
<fence/>
</clusternode>
<clusternode name="clusternode3.example.com" nodeid="3"
votes="1">
<fence>
<method name="1"/>
</fence>
</clusternode>
</clusternodes>
<cman/>
<fencedevices/>
<rm>
<failoverdomains/>
<resources/>
</rm>
</cluster>
After the cluster resources and service were configured, the cluster.conf file appears as follows.
<?xml version="1.0"?>
<cluster alias="ipmiclust" config_version="27" name="ipmiclust">
<fence_daemon clean_start="0" post_fail_delay="0"
post_join_delay="3"/>
<clusternodes>
<clusternode name="clusternode1.example.com" nodeid="1"
votes="1">
<fence>
<method name="1">
<device name="ipmifence1"/>
</method>
</fence>
</clusternode>
<clusternode name="clusternode2.example.com" nodeid="2"
votes="1">
<fence>
<method name="1">
<device name="ipmifence2"/>
</method>
</fence>
</clusternode>