-2-
Bulletin No. CRMCMOD-A Effective 2018-05-17
Drawing No. LP1052
SPECIFICATIONS
1. POWER: Power will be supplied by the CR3000 host device.
HSPA Max Power:
HSPA+ Mode: During continuous active webserver traffic
Instantaneous maximum: 5.4 W
Average: 3.5 W
GPRS Mode:
Instantaneous maximum: 15.0 W (1.1 msec every 4.6 msec)
Average: 8.5 W
2. LINK STATUS LEDs:
Link Status - Link Status LED shows cellular link condition.
3. COMMUNICATIONS:
Isolation from HSPA Antenna connector to CR3000 host device: 500
VDC for 1 minute.
4. ENVIRONMENTAL CONDITIONS:
Operating Temperature Range: -10 to 50 °C
Storage Temperature Range: -40 to +85 °C
Operating and Storage Humidity: 85% max. relative humidity, non-
condensing.
Altitude: Up to 2000 meters
5. CERTIFICATIONS AND COMPLIANCES:
CE Approved
EN 61326-1 Immunity to Industrial Locations
IEC/EN 61010-1
RoHS Compliant
UL Hazardous: File #E317425
Note: The HSPA module has been tested and found to comply with
the limits for a Class A digital device, pursuant to part 15 of the FCC
rules.
6. ANTENNA CONNECTOR:
SMA Female connector requires:
50 Ohm antenna with SMA male connector
Penta-band HSPA+ antenna (850/900/1700/1900/2100 MHz) for
global support.
Dual-band (850/1900 MHz) antenna for US and Canada only
Dual band (900/2100 MHz) for Europe only
Voltage Standing Wave Ratio (VSWR) should not exceed 2.0:1
The antenna cable should be 50 impedance, RG178/U or RG174/U
type and be able to connect to the RSMA (Male) jack bulkhead. The
antenna could be horizontal, vertical or right angled. Longer antenna
cable would equate to signal loss.
7. CONSTRUCTION: Case body is polycarbonate with stainless steel
cover.
8. CONNECTIONS: Antenna connector for external antenna.
9. MOUNTING: Screws to host
10.WEIGHT: 7.0 oz (198.45 g)
A
POWER
SUPPLY
+
-
VDC
CR3000 HOST
HSPA
POWER
SUPPLY
E
ISOLATED
PORT
ETHERNET
PORTS
D
ISOLATED
ISOLATED
ISOLATED
PORT B/C/D
C
COMMUNICATIONS
B
PORT A
PROGRAMMING
To Next Page
Loading...
