11
6.4 MODULE 4 - SETPOINT OUTPUT PARAMETERS (4-SEtPt)
PARAMETER MENU
The Setpoint Output Parameters are only active when an optional Setpoint
Output Module is installed in the meter. Some parameters in the menu will not
appear depending on the Setpoint Assignment and Setpoint Output Action. The
Setpoint Parameter Availability chart below illustrates this.
PARAMETER DESCRIPTION
BOUNDARY
bOUNd
LATCH
LAtCH
RATE ASSIGNMENT
TIMED OUT
t-OUt
BOUNDARY
bOUNd
LATCH
LAtCH
Yes No No Ye s No No
SPn VAL
Setpoint Value Yes Yes Yes Yes Yes Yes
SPn OUt
Setpoint Output Logic Yes Yes Yes Yes Yes Yes
SPn LIt
Setpoint Annunciator Yes Yes Yes Yes Yes Yes
SPn P-UP
Setpoint Output Power-up State No No Yes No No Yes
SPn tYPE
Setpoint Boundary Type No Yes No Yes Yes Yes
SPn StbY
Standby Operation (Low acting only) No Ye s No Ye s Ye s Yes
SPn AUtO
Counter Auto Reset Yes No Yes No No No
SP1 OFF2
SP1 Output Off at SP2 (SP1 only) Yes No Yes No No No
SP2 OFF1
SP2 Output Off at SP1 (SP2 only) Yes No Yes No No No
SPn rSt
Output Reset with Manual Reset Yes No Ye s Yes No Yes
SPn ChC
Change Display Color w/ Output State Ye s Yes Yes Yes Yes Ye s
Setpoint Output Time-out Value
TIMED OUT
t-OUt
COUNTER ASSIGNMENT (A or B) *
SPn tOUt
* BOUNDARY Setpoint Action not applicable for Counter B Assignment
Select the Setpoint Output to be programmed, starting with Setpoint 1. The
"
n" in the following parameters reflects the chosen Setpoint number. After
Setpoint 1 is completely programmed, the display returns to SPt SEL. Repeat
steps for Setpoint 2 if both Setpoints are used in the application.
Select NO to exit the Setpoint programming module. The number of Setpoints
available is dependent on the Setpoint option module installed.
SETPOINT SELECT
SP2SP1NO
"
#
NO
SPt SEL
SETPOINT 2 ENABLE (SP2 Only)
Select YES to enable Setpoint 2 and access the setup parameters. If NO is
selected, the unit returns to SPt SEL and Setpoint 2 is disabled.
YESNO
"
#
NO
SP2 Enb
SETPOINT ASSIGNMENT
SETPOINT PARAMETER AVAILABILITY
Select the display to which the Setpoint is assigned.
"
#
Count A
SPn ASN
SETPOINT OUTPUT ACTION
The parameter selects the action of the Setpoint Output as described in the
chart. Boundary output action is not applicable for Counter B assignment.
"
#
LAtCH
SPn ACt
Count A Count b rAtE
LAtCH t-OUt bOUNd
SPT ACTION DESCRIPTION OUTPUT ACTIVATES OUTPUT DEACTIVATES
LAtCH
Latched Output Mode
When Count =
Setpoint
At Manual Reset
(if
SPn rSt=YES)
t-OUt
Timed Output Mode
When Count =
Setpoint
After Setpoint
Output Time-Out
bOUNd
Boundary Mode
(Low Acting Type)
Boundary Mode
(High Acting Type)
When Count ≤
Setpoint
When Count ≥
Setpoint
When Count
> Setpoint
When Count
< Setpoint
To Next Page
Loading...
