Red rock TruShield User Manual

TruShield Pet Barrier Net
Installation Guide for Jeep Wrangler '07-'16 2-Door JK
Installation Time: <1 Hour
Tools Required:
 Box Cutter/Knife
 Pliers (optional)
Installation Instructions:
1. Carefully open the package using a box cutter or knife (Figure A) and ensure the product is included and
undamaged.
Figure A
2. Lay the netting out flat and find the Barricade label (Figure B).

Red rock TruShield Specifications

General

Brand	Red rock
Model	TruShield
Category	Automobile Accessories
Language	English

Summary

TruShield Pet Barrier Net Installation Guide

Unpack and Inspect Netting

Carefully open the package using a box cutter or knife and ensure the product is undamaged.

Position and Identify Netting

Lay the netting out flat and find the Barricade label before proceeding with installation.

Adjust Front Seats

Pull the front seats all the way forward to facilitate the installation process.

Prepare for Hardtop Installation

For hardtop installations, removing front hardtop panels may ease the process.

Route Top Passenger Strap

With the logo facing rear, run the top right strap over the sound bar from front to rear.

Secure Sound Bar Strap

Retrieve the strap on the other side of the sound bar and pull it down.

Fasten Top Strap Buckle

Run the retrieved strap through the buckle at the bottom of the same strap.

Repeat for Driver Side Straps

Follow steps 5-7 for the top straps on the driver's side of the vehicle.

Attach Bottom Seat Brackets

Find the strap with a metal hook and secure it around the outer seat bracket on both seats.

Tighten All Securing Straps

Tighten all straps, using pliers for additional leverage if necessary.