MAX 250 Hood Disassembling and Reassembling the hood
• Place the hood upside down on a at surface or if available on the original foam packaging.
• Unscrew the 6 lens screws located at the front of the lens.
• Rotate the lens to the upright position and remove from the brackets by pulling the lens towards the front.
• Put the lens in a safe place where it will not get scratched.
• If not already in place, insert all 6 light tubes into the hood.
• Carefully remove the 17 screw covers that hide the screws that hold the top and bottom parts of the Hood together.
• This is best done by using a thin, at blade screwdriver in the place provided.
• There is no need to remove the screw covers from the Front Cover.
• Unscrew the screws using a Philips screwdriver.
MAX 250 Hood Disassembling and Reassembling the hood
Disassembling the hood