RED SHIELD WS100G2 User Manual

USER GUIDE
WIRE-FREE HOME PROTECTION SYSTEM WS100G2
Section 1 – Getting started
1.1 General system overview
1.2 Introduction to the system
1.3 Items included with the system
1.4 Introduction to the Smart Panel
1.5 Introduction to the Smart Panel backlight
Section 2 – Installing the Wire-free Home Protection System
2.1 Installing the Smart Panel
2.2 Powering up the Smart Panel
2.3 Understanding the battery and AC adaptor icon
Section 3 – Using the Wire-free Home Protection System
3.1 Programming your 4-digit PIN
3.2 Transmitting an emergency (Panic) alarm
3.2.1 Using the Panic alarm
3.2.2 Using the Panic alarm without activating the siren
3.3 Operating different modes
3.3.1 STANDBY mode
3.3.2 ARM mode
A. Adjusting Exit Delay
B. Adjusting Entry Delay
C. Adjusting the Alarm Duration
D. Muting the Audible Countdown
E. Arming the system
F. Disarming the system
G. Zone settings
H. Triggers in ARM mode
3.3.3 ALERT mode
A. Entering the ALERT mode
B. Exiting the ALERT mode
C. Zone settings
3.3.4 HOME mode
A. Entering the HOME mode
B. Exiting the HOME mode
C. Zone settings
Section 4 – Installing the Sensors
4.1 Introduction to the Sensors
4.2 Installing the Sensors
4.2.1 Installing the Door/Window Sensor
A. Powering up the the Door/Window Sensor
B. Installing the Door/Window Sensor
C. Mounting with the double-sided adhesive pad
4.2.2 Installing the Motion Sensor
A. Powering up the Motion Sensor
B. Installing the Motion Sensor
C. Sensor sensitivity
D. Walk test
E. Mounting using screws
4.2.3 Introduction of Key Fob Remote Control
A. Introduction
CONTENTS
1
3
5
13

RED SHIELD WS100G2 Specifications

General

Brand	RED SHIELD
Model	WS100G2
Category	Protection Device
Language	English

Summary

Section 2 - Installing the Wire-free Home Protection System

2.1 Installing the Smart Panel

Guides on selecting a location and mounting the Smart Panel, including tamperproof switch.

2.2 Powering up the Smart Panel controller

Instructions for connecting the AC adapter and inserting the backup battery.

Section 3 - Using the Wire-free Home Protection System

3.1 Programming your new 4-digit PIN

Steps to change the default PIN to a personalized 4-digit code for system access.

3.2 Transmitting an emergency (Panic) alarm

How to activate an emergency alarm using the keypad or remote control.

3.3 Operating different modes

Section 4 - Installing the Sensors

4.2 Installing the Sensors

Section 5 - Troubleshooting

5.1 FAQs

5.2 Troubleshooting

Solutions for common issues like AC power failure, system battery failure, and sensor failure.