RED MOA - Page 32

32
User manual of electric heater RED MOA
Problem solving
Problem Possible cause Soluon
The device is plugged in,
no diodes are on.
Problem with the
connecon.
Check the connecon of
the power wire, the plug
and the socket.
Heang element is not
heang, outside diodes
are blinking alternately.
Temperature sensor has
been damaged.
Disconnect the device
completely, wait unl the
radiator cools down and
re-connect it again.
Overheang of device.
Check and conrm that
the heang element's out-
put does not exceed the
recommended output of
your radiator. Check and
reduce the water tem-
perature in the central
heang system-must not
exceed 82°. In electric-only
version check, if the radi-
ator is properly lled with
the heang agent.
The device is heang de-
spite turning it o with the
buon.
Damaged electronics.
Disconnect the device
completely, wait unl the
radiator cools down and
re-connect it.
If the problem connues please contact Your local Distributor.