Why is my Redback Lawn Mower working time between charges decreasing?
The working time between charges might be decreasing because the charging contacts are dirty. Clean the charging contacts on both the robot and the docking station, using steel wool to brush them lightly. Alternatively, the battery capacity may have diminished, requiring a battery replacement.
What to do if my Redback Lawn Mower has excessive vibration and noise?
If your Redback Lawn Mower is exhibiting excessive vibration and noise, it could be due to several reasons: the cutting system might be unbalanced or the blades are dull, in this case turn the power off and reverse or replace all three blades. Another potential cause is a damaged blade disc, which would need replacement. Lastly, check if the disc retaining screws are loose and tighten them securely.
Why won't my Redback MOWRO RM24 Lawn Mower leave the docking station?
If your Redback Lawn Mower isn't leaving the docking station, consider these potential causes: * The PIN may not be entered correctly. Try entering the factory default PIN (0000) or the PIN you set. * The battery may not be fully charged. Allow the robot to charge until the battery symbol shows 4 bars on the LCD screen. * The docking station might not be installed correctly. Ensure the 'IN' arrow on the docking station points to the inside of the working area. * The boundary wire may not be installed correctly. The wire end routed under the docking station should be connected to the positive (+) metal prong.
General| Cutting Width | 34 cm |
|---|---|
| Collection Capacity | 40 L |
| Cutting Height | 25-75 mm |
| Grass Bag Capacity | 40 L |
| Weight | 13.2 kg |
To Next Page
