This document provides instructions for the installation, use, and maintenance of Redfox electric contact grills.
Function Description
The Redfox electric contact grill is designed for professional use in kitchens to cook food by direct contact with heated plates. It operates by heating spirals that are controlled by a thermostat, allowing users to adjust the desired cooking temperature. The device is intended for indoor use only.
Important Technical Specifications
The manual lists several models with varying technical specifications:
PS - 2010 L/R:
- Voltage (V/Hz): 230/50
- Wattage (W): 3,000
- Dimensions of Plate (CM): 26 x 24
- Dimensions (CM): 30.4 x 40.5 x 18.2
- Weight (KG): 12
PM - 2015 L/R/LL:
- Voltage (V/Hz): 230/50
- Wattage (W): 3,000
- Dimensions of Plate (CM): 36.5 x 24
- Dimensions (CM): 40.9 x 40.5 x 18.2
- Weight (KG): 12
PD - 2020 L/R/M:
- Voltage (V/Hz): 400/3N/50
- Wattage (W): 6,000
- Dimensions of Plate (CM): 57 x 24
- Dimensions (CM): 61.4 x 40.5 x 18.2
- Weight (KG): 14
PD - 2020 LSL/LSP/RSL/RSP/MSL/MSP:
- Voltage (V/Hz): 400/3N/50
- Wattage (W): 4,800
- Dimensions of Plate (CM): 57 x 24
- Dimensions (CM): 61.4 x 40.5 x 18.2
- Weight (KG): 14
PS - 2010 LB/RB:
- Voltage (V/Hz): 230/50
- Wattage (W): 1,200
- Dimensions of Plate (CM): 26 x 24
- Dimensions (CM): 30.4 x 32.2 x 18.2
- Weight (KG): 28
PM - 2015 LB/RB:
- Voltage (V/Hz): 230/50
- Wattage (W): 1,800
- Dimensions of Plate (CM): 36.5 x 24
- Dimensions (CM): 38.7 x 32.2 x 18.2
- Weight (KG): 28
PD - 2020 LB/RB/MB:
- Voltage (V/Hz): 230/50
- Wattage (W): 2,400
- Dimensions of Plate (CM): 57 x 24
- Dimensions (CM): 59.2 x 32.2 x 18.2
- Weight (KG): 28
The device must be installed in a well-ventilated room. If placed near walls or furniture, these surfaces must withstand temperatures up to 90°C. A minimum distance of 10 cm from other objects and combustible materials must be maintained. The appliance should be placed under a fume hood to eliminate steam and odors.
Electrical connection requires a separate safety fuse corresponding to the device's wattage. An accessible switch with a minimum contact separation of 3 mm must be installed between the device and the electrical grid. The grounding feeder (yellow-green) must not be interrupted by this switch. The feeding cable must be positioned so that no point reaches a temperature 50°C higher than the ambient temperature. Effective grounding according to standards (ČSN) and legal conditions is required.
Usage Features
The Redfox electric contact grill is designed for skilled use and must be operated by qualified personnel only.
Operating Instructions:
- Switch On: Turn on the main switch (A).
- Adjust Performance: Turn the knob (D) to adjust the desired performance level.
- Indicator Lights: Pilot lamps (B) and (C) will light up.
- Pilot lamp (B) indicates that the device is operational.
- Pilot lamp (C) lights when the heating spirals are active.
- Pilot lamp (C) goes out once the device reaches the adjusted temperature.
- Switch Off: Turn the knob (D) to the "0" position, then switch off the main switch (A).
Important Notes for Use:
- Before first use, remove all protective foil and clean the device.
- During initial use, especially in the first 15-20 minutes, thermal insulators and grease residues may cause smoke and an unpleasant odor. It is recommended to operate the appliance empty at maximum power during this period and ensure adequate ventilation.
- Do not use the appliance if the supply cable or plug is damaged, if it is not working correctly, has fallen to the ground, or has been damaged by water. In such cases, take it to a professional service for inspection.
- Only adults should operate the device.
- The device must not be switched on without supervision.
- Only original spare parts should be used for repairs.
Maintenance Features
Regular cleaning and maintenance are crucial for extending the device's lifespan and efficiency.
Daily Cleaning:
- Disconnect Power: Always switch off the main feeder to the device and ensure it is disconnected from electricity before cleaning.
- Cleaning Method: The device cannot be cleaned by direct water jet or pressure shower.
- Stainless Parts: Wash stainless parts with a moist cleaning cloth and a non-abrasive detergent.
- Drying: Dry all parts thoroughly with a cloth.
- Avoid Harsh Cleaners: Do not use abrasive or corrosive detergents.
- Food Residues: Remove all food residues from the surface using a scraper if necessary.
- Lubrication: After each cleaning, lubricate the top plate with vegetable oil.
Periodic Maintenance:
- Professional Check-up: It is recommended to have the device checked by a professional service at least once a year (or a minimum of twice a year according to other language sections).
- Interventions: All interventions on the device must be performed by qualified and authorized personnel.
Troubleshooting:
- In case of a breakdown, switch off the electric feeder and contact the seller's professional service.
Warranty Information:
- The guarantee does not cover consumable parts subject to normal wear (e.g., rubber seals, bulbs, glass, and plastic parts).
- The guarantee is void if the device was not installed according to instructions by a qualified worker, if it was handled incompetently (interventions into inner equipment), or if it was operated by untrained personnel or contrary to the instructions for use.
- The guarantee does not cover damages caused by natural phenomena or other external interventions.
Disposal:
- At the end of its useful life, transport packaging and the device itself must be handed over to a collection point in accordance with waste and hazardous waste management regulations.
To Next Page
Need help?
General