REISSUE
If you reissue or are about to reissue this product, please thoroughly check all
components for their safety.
This includes:
• Bent or damaged tubes or cracks at the tube joints.
• Loose or worn horseshoe clips
• Elongated adjustment holes.
• Loose handles.
• Loose or worn Wheels and wheel fasteners (where fitted)
• Smooth, worn or split ferrules (rubber tips).
Replace all worn, missing or damaged parts where necessary. If in any
doubt,please do not issue or use, but immediately contact your supplier for
service support.
2. The brakes on your rollator have a park
option (fig. 13). To operate the park option,
push downwards on both brakes
simultaneously. You will feel the brake make
a very slight click. Your brakes are now in the
‘lock’ position.
3. To unlock, simply pull up the brake again,
you will hear a slight click as the ‘park’
disengages.
BRAKE ADJUSTMENT
Your rollator brake system will
require periodic adjustment. To
adjust the brakes loosen Nut B
and then screw/unscrew Nut A.
When adjusted re-tighten Nut B.
If further adjustment is required
then loosen the Locking Screw
and then using a pair of pliers
pull the cable down by
approximately a millimetre. Re-
tighten Locking Screw. The
brakes can then be adjusted
further by loosening Nut B and
screwing/unscrewing Nut A as
before（fig. 14）
To Next Page
