RDL-3100 RMA MODULE PRODUCT MANUAL
70-00184-05-00 Proprietary Redline Communications © 2017 Page 11 of 25 February 17, 2017
4 Final Product Requirements
The following requirements apply to all final products incorporating an RDL-3100-RMA,
module.
4.1 Frequency Bands
Operation of the final product requires a software 'key' that is available exclusively from
Redline. This key restricts device operation to the FCC/ISED 4940-4990 MHz, FCC
5150-5250 MHz or 5725-5850 MHz band. The professional installer and operator can
not modify or otherwise circumvent these operational restrictions.
4.1.1 Antenna Use and Transmit Power
The module supports operation with 2 x 2 MIMO antenna systems with two transmit
chains and two receive chains. The module must be used only with certified antennas
and using the channel size and output power level specified by the FCC/ISED
regulations.
4.1.2 Certified Antennas
This device has been designed to operate with the antennas listed in the following table.
Any additional antennas will be used only after authorization is obtained through Class II
permissive change.
Table 1: Approved Antennas
To Next Page
Loading...