Need help?Do you have a question about the RedNeck Deer and is the answer not in the manual?
General| Brand | RedNeck |
|---|---|
| Model | Deer |
| Category | Racks & Stands |
| Language | English |
Crucial safety warnings regarding compliance, user responsibility, and potential injury or death.
Warns against modification, misuse, or defects, voiding warranty and risking injury; stresses pre-use inspection.
Advises contacting One-Call before digging to prevent injury, service disruption, or environmental accidents.
Provides customer service contact and outlines the first step of unpacking and verifying parts.
Attaching two Porch Hand Rails to the base platform using specified hardware and connection methods.
Centering and securing the hunting blind onto the base platform using specific bolts and washers.
Provides specific instructions for 15' stand assembly and 6x6 Buck Palace Blind brace installation.
Attaching Upper and Lower Leg sections to the base platform and feet, with hand-tightening guidance.
Fastening Middle Perimeter Angles to the leg sections at the upper bolt hole of the leg joint.
Attaching Lower Perimeter Angles to the lower leg sections using the typical hardware connection.
Connecting Cross Braces between upper legs and middle perimeter angles with precise alignment.
Ensures bolts are tight, stand is level/stable, and references anchoring instructions before ladder assembly.
Assembles ladder components and securely mounts it to the platform using pins and stabilizers.
Confirms that all bolts are tight and securely installed after completing the main assembly steps.
Attaching Upper Legs and Feet to the base platform for the 5' configuration, hand-tightening hardware.
Fastening Middle Perimeter Angles to the leg sections at the upper bolt hole for the 5' stand.
Connecting Cross Braces to upper legs and middle perimeter angles for the 5' stand configuration.
Guidance on positioning and leveling the assembled 5' stand, similar to the 10' configuration.
Instruction to anchor the 5' stand by referencing the Tie Down Anchor Instructions on page 7.
Assembles and mounts the 5' ladder to the platform, securing it with pins and stabilizers.
A final check to ensure all bolts are tight and securely installed for the 5' stand.
Critical warning against using an unlevel or unstable stand, requiring immediate readjustment.
Instructions on driving leg stakes at an angle for secure ground anchoring of the stand.
Finding the ground spot below the base platform and preparing the soil for auger or concrete installation.
Details on digging a hole, placing the auger, and pouring concrete for a secure anchor.
Connecting wire rope and turnbuckle to the base platform and auger for secure anchoring.
Lists the components included in Box #1, such as the base platform, ladder sections, and hardware kit.
Lists the components included in Box #2, primarily the upper and lower leg sections.
Lists the components included in Box #3, such as perimeter angles and cross braces.
Lists all necessary tools for assembling the deer stand, including wrenches, sockets, and digging tools.
Explains the footprint measurement of the 10' stand, specified as 7' 8.5" square from the leg foot center.
Instructions on using the provided rope and carabiner to hoist gear into the Redneck Blind platform.
To Next Page