8
Routing
RedNet Control can perform basic routing operations. RedNet Control supports one
single “host” at a time. This could be:
• One RedNet PCIe
• One Pro Tools HD system with up to six RedNet 5 units
• One DVS instance
Routing is via a drag-and-drop operation in the RedNet Control application,
routing consecutive channels between the I/O units to/from the host device(s).
For more information please refer to the system guide.
Advanced routing, such as between I/O units, on systems with multiple “hosts” or
to set up one-to-many routings can be performed with Dante Controller. This provides
a traditional crosspoint matrix interface.
Troubleshooting
For a list of FAQs and general troubleshooting tips, our Answerbase is a valuable
resource. This can be found here: www.focusrite.com/answerbase
If any problem cannot be resolved, or if you have a query, please contact our Customer
Support team using the contact details found here;
• Email: rednetsupport@focusrite.com
• Phone (UK): +44 (0)1494 462246
• Phone (USA): +1 (310) 322-5500
Routing & Troubleshooting
To Previous Page
Loading...