8
Channel names
Monitors with more than one channel are shown on the graph with several traces
identified by numbers. It is helpful to be able to give the channels names as well as
these numbers. Channel 1 should always be used in PU monitors for the
temperature of the product being pasteurised and so this channel could perhaps be
named "PRODUCT". The second channel could be used to measure the water spray
temperature in the pasteuriser and so could be named "SPRAY". These names
appear on the printed results and help to make them easier to interpret.
SET CHANNEL NAMES lets you set up names for the three possible channels of the PU
monitor. The names can have up to 15 characters (letters or numbers). Channels 1
and 2 are temperature channels; channel 3 is the pressure channel. When used with
monitors having fewer than three channels the extra names are ignored. The names
you set apply to all PU monitors; you cannot set different names for individual
monitors.
Note. Channel 3s name is always used for the pressure channel. The older 100
Series RPT-122 pressure monitor has only two channels. The pressure channel is
channel 2 and will use trace No 2 on the graph but will use the name you set here for
channel 3.
After you have set up the graph format for the PU monitor user you will be returned
to the SET GRAPH FORMATS display where you can exit this part of the setting section
by pressing the CANCEL button. If you continue by pressing the OK button you can
make further changes to the formats.
Leaving Graph Formats section
After you have set up the graph format for the PU monitor user you will be returned
to the SET GRAPH FORMATS display where you can exit this part of the setting section
by pressing the CANCEL button. If you continue by pressing the OK button you can
make further changes to the formats.
All the graph format settings are printed on the Status Report for the RPC-80. See
Manual-1.
To Next Page
Loading...