20
• Mount The Rear Camera
• Wire Layout In The Vehicle
Open the trunk of the vehicle, remove the screws, remove the
plastic panel.
P open the license plate light and pass the rear camera cable
through the hole where the license plate light is located.
The car charger is connected to the cigar socket.
Connect the other end of the car charger to the dash cam.
1
1
2
2
Note:
This rear camera is specially designed to tolerate a variety of
environmental conditions, and is better suited installed on the
outside of the vehicle. The lens parameters are set with the
assumption that the camera will be used outside, therefore it is
recommended that you install the camera on top of the license
plate frame. If this is not possible, we have a license plate frame
bracket to solve this issue.
To Next Page
Loading...
