Reece Base User Manual

Installation Instructions
Base Vanity Unit
Please ensure a copy of the installation
instructions is left with the end user for future reference
CLEANING RECOMMENDATIONS
We recommend the use of soapy water or
approved cleaners for the Vanity Top.
Cabinets are moisture resistant. Cabinet
surfaces should be cleaned with a damp
cloth and dried.
This product should not be cleaned with
abrasive materials.
Damage caused by any improper treatment
is not covered by the product warranty - refer
to Warranty Conditions
Assembly Instructions - Vanity Unit - 2 Doors
Installation Instructions
1. Set up water inlet point and waste
for
vanity top.
2. Place vanity into position and
ensure it is level (make minor
adjustment if required).
3. Drill pilot holes in the back of the
unit and fix unit to the wall using
suitable screws. Ensure that the
screws are fixed securely into a
solid wall or timber noggin. Minor
adjustments may need to be
made to align drawer runners and
hinges.
4. All final door and drawer
adjustments are the responsibility
of the installer at the time of
installation.
5. External edges where the
unit meets the floor and wall
should be sealed using flexible
waterproof sealants.
Published 19/12/2019

Reece Base Specifications

General

Brand	Reece
Model	Base
Category	Indoor Furnishing
Language	English

Summary

Assembly Instructions - Vanity Unit

Water Inlet and Waste Setup

Prepare water inlet and waste connections for the vanity top before installation.

Positioning and Leveling

Place the vanity in its final position and ensure it is level, making minor adjustments if needed.

Wall Securing

Drill pilot holes in the back of the unit and fix it to the wall using suitable screws into solid support.

Door and Drawer Adjustments

The installer is responsible for all final door and drawer adjustments at the time of installation.

External Edge Sealing

Seal external edges where the unit meets the floor and wall using flexible waterproof sealants.

Cleaning Recommendations

Vanity Top Cleaning

Use soapy water or approved cleaners for the vanity top.

Cabinet Surface Care

Clean cabinet surfaces with a damp cloth and dry; avoid abrasive materials.

Warranty Information

Damage caused by improper treatment is not covered by the product warranty.