Reed Instruments R9200 - Operating Instructions; Microwave Oven Safety Standards; Battery Replacement

5
Operating Instructions
1. Turn the meter on by pressing the POWER button.
2. Whilepoweringon,thewarning/overalarmwillbeepand
blink simultaneously.
3. Upon start up, hold the /ZERO buttontoperformazeroadjustment.
4. The LCD will now display a measurement value of 0.00
5. Totakeameasurement,placethemeter2"fromthedoorsealsor
the front glass of the microwave.
6. Press the MAXbuttontothedisplaytheMaximumvalueduringthe
measurement process.
7. To turn the meter off, press the POWER button.
Microwave Oven Safety Standards
IntheU.S.,checkwithTheFoodandDrugAdministration(FDA),while
inCanada,checkwithHealthCanadaformicrowaveovensafety
standardswithregardtoleakagerequirements.TheFDA'slastupdate
in2017limitstheamountofmicrowaveleakageto5milliwatts(mW)of
microwaveradiationpersquarecentimeteratapproximately2inches
from the oven surface. This limit is far below the level known to harm
people. Microwave energy also decreases dramatically as you move
away from the source of radiation. Be sure to be up to date in regards
to the current standards and regulations for the appropriate country
before using this device. REED Instruments will not be held
responsibleforanydamagetotheequipmentorpersonalinjuryin
regards to the use of this meter or in the correct interpretation of the
appropriate safety standards. The user assumes full safety
responsibility at all times.
Battery Replacement
When the low battery icon appears on the LCD display, you will need to
replace the batteries. Remove the battery cover using a Phillips head
screwdriver,insertanew9Vbatteryandsecurethecover.
REED Instruments
1-877-849-2127 | info@reedinstruments.com | www.reedinstruments.com