Normal time display mode
Shows minute, second and day of the week. It also allows you to turn the alarm on
or off (see Alarm On/Off).
When you are in Normal Time Display mode (Figure 1), press
• SPLIT/RESET button to see the Alarm Time
• MODE button to change the Mode to Stopwatch Mode
• START/STOP button to show month, day of the week
Stopwatch function
Make sure stopwatch is in Normal Time Display mode. If the current display is not
the Normal Time Display mode, press the MODE button until SU, FR and SA starts
flashing together along the top of the LCD (Figure 2).
Accumulated elapsed time measurement:
Make sure the timer is reset back to 0:00:00 by pressing the SPLIT/RESET button.
1. Press the START/STOP button to start and stop the timer.
2. Press the SPLIT/RESET button to reset the timer back to 0:00 00.
Split time measurement:
Make sure the timer is reset back to 0:00:00 by pressing the SPLIT/RESET button.
1. Press START/STOP button to start the timer.
2. Press SPLIT/RESET button for split time.
3. Press SPLIT/RESET button again to release the split.
4. Press START/STOP button to stop the timer.
5. Press SPLIT/RESET button to reset the timer back to 0:00 00.
Measurement between two competitors:
Make sure the timer is reset back to 0:00:00.
1. Press START/STOP button to start the timer.
2. Press SPLIT/RESET button to start the split time.
3. Press START/STOP button to stop the split time.
4. Press SPLIT/RESET button to view the split time.
5. Press SPLIT/RESET button again to reset the timer back to 0:00 00.
• Real time and plit times recorded
• Easy-to-read display
• 48" nylon lanyard
• Batteries included
• One year warranty
Lap reset
Mode Selection
Start/stop/set
Alarm set indicator
48" nylon lanyard
Shock and water
resistant case
Day of the week
indication
Features
Figure 2
Figure 1
reedinstruments
www
com
Model
SW600
Stopwatch
Minutes, seconds
1/100th second display
REED Instruments
1-877-849-2127 | info@reedinstruments.com | www.reedinstruments.com
To Next Page
Need help?
General
