Apart from the Dosing pump device itself, the package contains the following elements: a pump, a
pump cylinder head, a 12 V power supply unit, a magnet that can be used to reset the device, an
abbreviated manual and a silicone hose for dosing liquids. In order to set up the device correctly,
follow the steps below.
1. See the figures below to learn how to connect the peripherals to the Dosing pump device
correctly. Notice the designations of individual elements, so as not to confuse them while
connecting.
2. Install the dosing head on the pump, cut the silicone hoses to appropriate length, remove the
connector guards from the pump cylinder head and then connect the hoses to the connectors.
Place the ends of silicone hoses in the tank with a liquid to be dosed and in the aquarium
tank.
CAUTION: check whether the pump flow direction is correct, that is whether the liquid
is pumped to the aquarium and not the other way around.
3. After performing these actions, place the pump in a safe location in a convenient position (the
pump may operate in any position) and connect the power supply using a dedicated 12 V
power supply unit.
To Next Page
Loading...