Page 11 Ascento Group Australia P: 1800 807 604 E: csv@ascento.com.au
WARNING!! ELECTRICAL PRECAUTIONS
Before servicing a pump, always shut off the power supply and then make sure you are not
standing in water and that there is no risk of electrical shock.
If the pump is direct-wired to the electrical circuit, contact a qualified licensed electrician to
disconnect it before attempting any repairs or servicing.
DO NOT ATTEMPT ELECTRICAL REPAIRS OF ANY SORT UNLESS YOU ARE A LICENSED ELECTRICIAN
PARTS: Enquire for parts availability as most are not stocked. Repair should not be attempted by unqualified persons
and consideration should be given to the economics of attempting repair.
INSTALLATION CHECKLIST: MUST BE FILLED IN FOR WARRANTY TO APPLY
Installer Name: ………………………………………………………………… Phone Number: ………………………………
Qualification: …………………………………………………………………………………… (write Owner if applicable)
If installed by a Plumber or Electrician – Licence No: ……………………………………………………………………
Installation Address: ……………………………………………………………………………………………………………………
Tick the boxes as the item is completed/correct, put n/a if not applicable;
[ ] The Pump is being used for an appropriate purpose for which it is intended, according to the instructions
[ ] The Power Circuit the Pump is connected to is RCD (Safety Switch) Protected
[ ] All swarf has been removed from the tank after cutting openings etc.
[ ] Barrel Unions are fitted on the pipe connections for easy removal & replacement
[ ] Pipe is sized appropriately for the application (diameter and length)
[ ] The installation is constructed so the pump can be easily removed or replaced.
[ ] If applicable: The pump is installed in accordance with National & Local Plumbing Regulations
[ ] The Electrical Supply cable of the pump is plugged into a Power Outlet that is in accordance with the current
standard of Electrical Safety Regulations AS/NZS 3000 – or the pump has been wired directly to the power circuit by a
Licenced Electrician, with a suitable isolation switch in an easily accessible area.
[ ] The Pump has been started, tested, and operates correctly.
[ ] The pipes and connections and the barrel-union on the pump, and toilet cisterns (if connected) have been checked
for leaks.
WARRANTY RECORD - FILL IN AND RETAIN THIS WITH YOUR ORIGINAL PURCHASE RECEIPT
PURCHASER NAME………………………………………………………………………………………… PHONE NO…………………………………………………
DATE OF PURCHASE ………/………/…………… DEALER/STORE NAME………………………………………………………………………………………
DEALER SUBURB/TOWN………………………………………………………………………………… PHONE NO…………………………………………………
BRAND & MODEL NUMBER OF PUMP…………………………………………………… SERIAL/BATCH NUMBER……………………………………
Do NOT send this form to us, retain it for your record.
To Next Page
Loading...
