2
CAUTIONCAUTION
Ulisse UPC photocell meets the requirements of a type 2 safety device only if
connected with a certified safety interface in accordance with the Machine
Directive (89/392 IEC and amendments) and with the standard IEC 1496-1, 2.
ReeR SpA will not be liable for any consequence arising from the use of Ulisse
UPC photocells under conditions differing from the ones described above.
FEATURESFEATURES
• Through-beam barrier type photocell
• Robust and compact metal housing with flat glass lenses. Ulisse is therefore vibration-
resistant, as well as easy to clean and immune to the electrostatic attraction of dust. This
makes it particularly suitable for the use in the textile industry environment. textile industry environment.
• Power supply lines protected towards reverse polarity connections.
• PNP type switching output protected towards short-circuit.
• No false triggering on power-up.
• Test input, which allows the sensor to be tested by a remote controller
• Suitable for risk applications according to IEC 1496 (see par. "Use as a part of a(see par. "Use as a part of a
safety system").safety system").
• Led indicators on both emitter and receiver.
• Complies with 336/89/EC ("EMC Directive") and 23/73/EC ("Low voltage directive").
• Miniature M8 connector.
Ulisse is also available in the UNC version which, in connection with
the control units REER AUS3 or AU S-TWIN, can form a type two,
through-beam, single or double-beam safety light barrier.
To Next Page
Loading...
Need help?
General