Remark:
Before switching on the unit, please make sure that the unit is properly
connected to the power supply or that the batteries still have sufficient power.
Please use only one type of power supply at a time. Either AC by power cable
or DC by batteries.
Note:
The unit will automatically switch to standby mode if no audio signal is active in AUX / CD
mode within 15 minutes.
Please note that a low volume setting in the unit may be detected as "no audio signal" and
the unit will automatically switch to standby mode. To switch the
To switch the unit on again, press and hold the [9] button for about 3 seconds.
Notes on electrostatic discharge
The unit may be reset due to electrostatic discharge.
If the unit can no longer be operated, simply switch the unit off and restart it.
Volume: Adjusting the volume
Press the [6] / [4] keys to increase or decrease the volume.
CD MODE
Starting CD playback
1. Press the button [1] repeatedly until "CD" appears in the display.
2. Open the CD compartment by lifting the [14] position. Insert the
CD into the CD compartment with the title side facing upwards and close the CD
compartment.
3. The CD is now read in and the total number of tracks is shown in the display.
4. The unit automatically starts playing the first track of the CD.
5. When all tracks have been played, the unit stops automatically and the total number
To Next Page
Loading...