23
Remote Control:
1. Mute On / Off
2. Previous track.
3. Select mode.
4. Microphone recording.
Press the "REC" button to
record when a USB or
micro SD card is
connected.
NOTE: Only input from the
microphones will be
recorded.
5. Decrease microphone
echo effect.
6. Adjust the bass.
7. Set the equalizer.
8. Adjust the microphone
volume.
9. On / Off (standby).
10. Play / pause.
11. Next track.
12. Set the LED color.
13. Repeat track (On / Off)
14. Recording Playback.
15. Delete microphone
recording.
16. Increase microphone echo
effect.
17. Set microphone priority.
18. Adjust the treble
19. Adjust the volume
20. USB / SD: track selection,
FM: set frequency
POWER SUPPLY
This device has a rechargeable lithium battery (3000mAh / 7.4V). Charge
the PS09BT fully (approx. 4 hours) before using it for the first time.
BATTERY CHARGING
Plug the power pack included in the scope of delivery into the [DC In]
charging socket of the device.
The charge status is shown on the display.
Low battery: LED lights red.
Charging process: LED lights orange.
Charging finished: LED lights green.
Note:
The battery is permanently installed and may only be replaced by
qualified service personnel.
If the device is not used for a long period of time, the device should
be charged every 2-3 months in order to avoid deep discharge of the
battery.
To Next Page
Loading...
