20
USB / MICRO SD MODE
Play music from a USB stick or micro SD card on the SB300. USB sticks and micro SD cards up to a maximum of
32GB in FAT32 format are supported. The supported file formats are MP3 and WAV. Do not connect hard
disks to the USB socket or use a USB extension to connect a USB stick to the unit, and do not attempt to
charge USB devices via the USB port. You risk overloading the USB port and damaging the SB300 and the
connected device. Please use only the USB Type-A port for playback. The USB Type-C port is only for charging
the built-in battery. Proceed as follows to start playback.
1. Switch on the SB300.
2. Insert a USB stick into the USB socket or a micro SD card into the micro SD card slot. Insert the micro SD
card into the micro SD card slot with the printed side facing up until it clicks into place. To remove the
micro SD card, push the micro SD card in a short distance. The card then moves out a little and can be
removed.
3. The SB300 automatically switches to USB or micro SD card mode. An announcement announces the
mode.
USB mode: USB mode
TF card mode: Micro SD card mode
4. You can also switch to the corresponding mode manually by pressing the Mode button.
5. Playback starts automatically after the USB stick or micro SD card has been read in.
6. You can control playback with the buttons as described above under "Playback buttons".
Note:
Please do not use excessive force to insert the USB stick or micro SD card into the unit. You risk
damaging the connections on the unit or the USB stick and the micro SD card.
AUX-IN MODE
Connect an external device such as a smartphone, TV or MP3 player to the SB300 using a 3.5mm audio cable
to play music from your external device via cable. MP3 player, TV set and smartphone are not included.
1. Switch on the SB300.
2. Connect your external device to the AUX port of the SB300 using a 3.5mm audio cable.
3. The SB300 automatically switches to AUX mode. An announcement says the mode "AUX mode".
4. You can also switch to AUX mode manually by pressing the mode button.
5. Start the playback on your external device.
6. Control the playback with the external device.
7. You control the volume on your external device and the SB300.
Note:
If the basic volume on your external device is set too low, you may not be able to hear any sound
from the SB300. In this case, increase the volume on your external device.
To Next Page
Loading...