Once playing the CD you can then activate the Pause function by
pressing the pause button on the remote or pressing play/pause
button on the front panel.
Pause will then hold track position until the play button is pressed
on either the remote or front panel.
Once play is activated again the display shows all information about
the track and will continue to play from held position.
Stopping the player.
Pressing the stop button on either the remote or front panel will stop
the current action and return the player back to track 1 of album 1.
Whilst in ‘stopping mode’ the player locks out all other functions.
Track Previous
When pressed while the disc is playing, the current track will start
again from the beginning.
Pressing again in quick succession will take you to the start of the
previous track.
Track Next
Pressing once while the disc is playing, the next track will start from
the beginning. Pressing again takes you to the beginning of the next
track after that, etc.......
If the TRACK buttons are pressed in pause and stop modes, a
specific track can be selected, and when the PLAY button is pressed
the selected track will start from the beginning.
9
To Next Page
Loading...
Need help?
General
