188
System Installation
Refer to the photo on the previous page for
installation tips. For further information contact your
closest authorized Regal dealer.
The main system components integrate reinforced
canvas with straps, carbon-fi ber fl exible poles,
retainer rings, camel backs, and stanchions. Note
that the sunshade system is only available on select
vessels with hardtops.
To install the bow sunshade do the following:
1. Connect the hardtop canvas latches to the camel
backs sewn into the canvas on both the port and
starboard forward ends of the hardtop. See A.
2. Note that the carbon fi ber poles are designed to
be collapsable. To install open the poles to the fully
extended position.
3. Install each of the poles in the forward sewn in
rings at the forward canvas corners. Once the poles
are inserted into the ring retainers check that they
are positioned fi rmly. See B.
4. Raise each pole and insert the bottom end into
the deck mounted stanchion. Note that the poles
are normally in a bent position when installed which
will assist addtionally in holding the retaining ring at
the top of each pole. See C.
5. Latch the collapsable support that extends across
the sunshade canvas. This support adds stability to
the sjunshade and holds its shape while positioned.
See the photo on the previous page.
5. Once the poles are positioned in the deck
stanchions connect the port and starboard middle
straps to the deck mounted camel backs and tighten
each strap as needed. See D.
6. If installed use a similar installation procedure
with the stern sunshade.
7. Store system components in a dry bilge location
when not in use.
A
B
C
D
To Next Page
Loading...
