234
Recommissioning Checklist
Engine
• Check all components per engine manufacturer’s
owner’s manual especially fl uid levels.
• Run engine on “ear muffs” (flushette) before
launching. Check for fuel, exhaust, oil, and water
leaks.
Boat
• Install drain plug.
• Install battery and tighten all terminals.
• Check all equipment, switches, alarms, gauges
and breakers for proper operation.
• Add necessary chemicals and water to chemical
head.
• Add water to water tank. Turn on faucet to purge
tank. Refi ll water tank.
• Make sure all safety gear is on board and in
excellent working condition.
• After launching, check controls and systems for
proper operation through chart plotter screen/
information panel.
• If electric toilet installed fl ush to check operation.
Also, check toilet system for leaks.
• If thruster on board after launching check operation
in both port and starboard direction w/ joystick.
Trailer
• Make sure all equipment is in excellent working
condition including all winch, tongue jack, brake
actuator and lines.
• Check all trailer lighting including running, turn
signals, and brake lights.
To Next Page
Loading...
