6
Figure 2
BASIC OPERATION
1. Insert a fully charged battery pack into the battery
compartment located at the front of the device. The latch
should engage to secure the battery pack to the device.
2. Tip the device onto either side or back panel and fully
insert the desired sensor (slider) into the receiver located in
the bottom of the device. Return the device to its operating
position (wheels down).
3. Center the device directly over the test area, noting the
approximate location of the sensor (side arrow labels).
When performing wet tests, be certain the sensor touches
down onto the applied liquid film. Avoid getting the wheels
wet, which could induce a wheel slip condition. Press any
switch momentarily to power up the device. There will be a
slight delay before the display illuminates.
To Next Page
Loading...