WATER AND PLUMBING OPERATION REGENCY ULTRA MOTORHOME
W a t e r a n d P l u m b i n g O p e r a t i o n | 56
Disconnecting the External Water Supply
o Turn off the city water supply.
o Relieve the water pressure in the line by
opening a faucet in the motorhome.
o Disconnect the hose from the city water
connection.
o Replace the protective plug over the city
water connection.
Filling the Fresh Water Tank
City Water
o Connect the water hose to the city water
connection.
o Turn the water fill selector valve to water
tank fill.
o Turn on the city water supply.
o Depress and hold the fresh water tank level
switch to show the percent-full level on the
LED display. Once the fresh water level reads
full on the LED display, turn off the city water
supply.
o Turn the water selector valve to the city
water position.
o Turn on the water pump switch on the
system monitor panel in the cabinet above
the coach entrance doorway.
o Slowly open the cold water tap until the
water runs smoothly. Repeat with the hot
water taps.
Potable Water
When a city water supply connection is not available,
fill the fresh water tank using the following
procedure:
o Fill a suitable water container with potable
water.
o Place the suction hose attached to the
winterize bypass valve into the potable water
container.
NOTE: The winterize bypass valve is located in the
exterior utility center.
o Turn the winterize bypass valve to
“WINTERIZE” and water fill selector valve to
water tank fill.
o Turn on the water pump switch on the
system monitor panel.
o Depress and hold the fresh water tank level
switch to show the percent-full level on the
LED display. Once the fresh water level reads
full on the LED display, turn off the water
pump.
o Turn the winterize bypass valve to “NORMAL
FLOW” and the water fill selector valve to city
water.
To Next Page
Loading...
