CUSTOMER SERVICE CENTRE 1300 780 250
Sprayer User Guide − "REAL" Drum Top Sprayer
Instructions For Use
• Position the "REAL" Drum Top Sprayer on top of the container you wish to dispense
from and insert the clear plastic suction hose. The brass suction nozzle has been
threaded so that a garden hose may be connected to it to lengthen the suction line or
give the operator the ability to spray water. The maximum vertical self prime is 4.5m.
• Check the switch is turned to the "OFF" position, then connect to the power source. For
the AC version, insert the plug into a grounded power outlet. For the DC version,
connect the RED (+) clamp to the positive battery terminal. Then connect the BLACK (−)
clamp to a grounded metal portion of the chasis or engine. For stand alone battery
applications the BLACK (−) clamp may be connected directly to the negative battery
terminal.
• Position spray wand tip into container to dispense from, squeeze the spraygun trigger,
and move switch to the "ON" position to allow unit to prime. Alternatively, remove the
spray control gun, insert end into container, move switch to the "ON" position and allow
unit to prime.
• The pump is primed once straight liquid is discharged from the spray wand, rather than
a mixture of air and liquid. When primed, move switch to "OFF" and connect the spray
gun and wand if not already connected. If the product must be circulated before
spraying, leave unit "ON" with hose or wand end in the container and allow product to
circulate. The "REAL" DrumTop Sprayer is supplied with a recirculator kit which will
continue to recirculate material during operation. Allow time for initial mixing before
commencing spraying.
To Next Page
Need help?
General