How to install missing device drivers for Reiner jetStamp 790?
If you encounter missing device drivers for your Reiner Printer, install the driver "USB- driver_Win_Vista_xP" from the provided CD using the 790 PCset easy - O - installation process.
What to do if Reiner Accessories show Error 09?
If you encounter the 'Error 09' message on your Reiner Accessories device, it might be due to a defective sensor or motor, or a blockage in the print carriage. To resolve this, press the [QUIT] button and attempt to start the stamping process again.
Why does my Reiner Accessories say 'IMPRINT BLOCKED'?
If the 'IMPRINT BLOCKED' message appears on your Reiner Accessories device, it means the time allowed by ‘Block Imprint’ has expired, or the disappears trigger has been pressed. To clear this message and resume use, press the [QUIT] button. The jetStamp will then be ready for operation again.
What to do if Reiner Accessories show 'WRONG STATION' error?
If the 'WRONG STATION' error appears on your Reiner Accessories device, it indicates that the jetStamp requires an intelligent base station. To resolve this, press the [QUIT] button. This will clear the error message and restore the previous display.
How to fix Error 04 on Reiner Accessories?
If you see 'Error 04' on your Reiner Accessories device, press the [QUIT] button.
What to do if Reiner Label Maker displays 'IMPRINT BLOCKED'?
If your Reiner Label Maker displays 'IMPRINT BLOCKED', this means the print triggering is blocked. Press the [QUIT] button to resolve this.
What to do if Reiner Label Maker displays 'WRONG STATION'?
If your Reiner Label Maker displays 'WRONG STATION', it indicates an incorrect charging station. Press the [QUIT] button.
What to do if Reiner Label Maker displays 'ERROR 09'?
If your Reiner Label Maker displays 'ERROR 09', it indicates that the sensor or motor is faulty, or the print carriage is blocked. Press the [QUIT] button.
What to do if Reiner Label Maker displays 'ERROR 04'?
If your Reiner Label Maker displays 'ERROR 04', it means there is a memory error. Press the [QUIT] button to attempt to clear the error.
Why does my Reiner Label Maker say 'CHARGE BATTERY NO IMPRINT POSSIBLE'?
The 'CHARGE BATTERY NO IMPRINT POSSIBLE' message on your Reiner Label Maker indicates that the batteries are discharged. You should charge the batteries.
Identifies and describes the various physical components and controls of the jetStamp.
Explains the layout of the device's display and the functions of its buttons.
Defines safety levels (DANGER, WARNING, CAUTION, NOTICE) and their implications.
Specific safety precautions and warnings related to battery use and disposal.
Guidelines for safe handling and storage of ink print cartridges.
Instructions for properly installing a new ink print cartridge.
Step-by-step guide on how to print an imprint using the jetStamp.
Final steps to print a configured imprint onto a surface.
General| Technology | Inkjet |
|---|---|
| Connectivity | USB |
| Battery | Rechargeable lithium-ion battery |
| Type | Portable inkjet printer |
| Maximum Print Speed | 3.5 inches per second |
To Next Page
