Need help?Do you have a question about the REITZ Design KXE and is the answer not in the manual?
Explains danger, warning, and notice symbols for safety.
Defines requirements for qualified persons working on the fan.
Defines requirements for qualified persons working on the fan.
Specifies requirements for personnel handling electrical components.
Details mandatory PPE for safe fan operation and maintenance.
Summarizes potential hazards and corresponding safety measures.
Details responsibilities regarding safety, operation, and maintenance.
Details safety configurations for power failures to prevent hazards.
Outlines measures to ensure safe working conditions and prevent accidents.
Explains how to level and align the fan at the installation site.
Covers procedures for assembling the fan, including site requirements.
Step-by-step guide for assembling the fan components.
Explains how to secure the fan to the substructure before commissioning.
Details the procedure and permissible offsets for coupling alignment.
Explains how to measure impeller clearance to prevent abrasion.
Details procedures for connecting ductwork to the fan inlet and discharge.
Explains how to activate automatic re-lubrication devices before initial startup.
Details safety requirements and responsibilities for electrical connections.
Defines limit values for pre-alarm and disconnection of monitoring devices.
Specifies vibration limit values for pre-alarm and disconnection.
Defines limit values for bearing temperature pre-alarm and disconnection.
Provides a checklist for verifying the fan's installation before startup.
Covers points to observe during power-up and parameters to record.
Details emergency shutdown activation via the control system.
Describes bearing variants and information found on fan plates.
Describes shaft seal variants and hazards of ineffective seals.
To Next Page
General