• The standard HIGH-LEVEL hook up procedure is: attach the red wire to the amplifier’s right positive
speaker output terminal; attach the yellow wire to the amplifier’s left positive speaker output terminal;
attach the black wire to whichever of the amplifier’s ground output terminals is convenient; plug the
Speakon connector into the Sub-Bass System’s HIGH-LEVEL input.
Supplied Neutrik Speakon
H
I
G
H
-
L
E
V
E
L
I
n
t
e
r
c
o
nnec
t
H
I
G
H
-
L
E
V
E
L
Input
R
e
l
e
a
s
e
L
e
v
e
r
Y
e
ll
o
w
B
l
a
ck
Re
d
+
L
–
+ R
–
Amplifier Main Speaker
O
u
t
pu
t
s
• For differential (i.e. fully balanced) amplifiers using one REL, simply use the standard connecting scheme
with the exception of connecting the black wire to chassis ground (i.e. a metal bolt or screw, preferably
not painted or anodized, on the chassis of the power amp or receiver), not to a negative speaker
terminal, and then connecting into the HIGH-LEVEL input on the REL. Please contact your dealer should
there be
any questions concerning this or any other hookup procedure.
Supplied Neutrik Speakon
H
I
G
H
-
L
E
V
E
L
I
n
t
e
r
c
o
nnec
t
Y
e
ll
o
w
Re
d
B
l
a
ck
+
C
hass
i
s
S
cr
ew
+ L – + R
–
Amplifier Main
S
pe
a
k
e
r
O
u
t
pu
t
s
NOTE: The TZERO is equipped with internal circuitry to allow seamless connection to Class-D (digital) main
amplifiers. If connecting to a Class-D amplifier, follow the above connection procedure for differential
amplifiers.
10
To Next Page
Loading...
