Relay MR005DL - Addendum; Error Codes; Modem Configuration

User Manual MR005FA+DL / MR006FA+DL ·04/2018 · VERSION 1.4
17
MR005FA+DL / MR006FA+DL
9 Addendum
9.1 Error Codes
The following table shows the error codes. See “Error fixing – Status: Error”:
Code
Error
$00
No error
$01
RAM error (please send the device to us for repair)
$11
EEPROM write problem
$18, $19, $1C
EEPROM read problem
$20
Problem with communication to real time clock
$30, $31, $32, $33
Problem with FLASH memory
$51,$52
Problem with data in real time clock
$61, $62
Problem with YModem transmit , Xmodem reception
9.2 Modem Configuration
You must configure the modem before it is connected to MR00xFA or MR00xDL. Please use a
terminal software of your choice, e.g. the Windows HyperTerminal and connect the PC to the
modem. Choose 9600 baud, 8 data bits, no parity and one stopbit. Then input the following
commands and activate each with the “Enter” key:
Command
Function
AT
for baudrate detection
AT&F
load factory settings
AT&D3
resets modem after DTR signal off
ATS0=1
modem answers a call after one ring
AT\Q0 or AT&K0
deactivate hardware and software handshake
AT\J0
no adaption of the serial baudrate to line speed
AT&W0
stores the settings into profile 0
AT&W1
stores the settings into profile 1
These commands are examples, which will work with several, but not all modems on the market.
Please study the manual of your individual modem to find out whether you need to use modified
commands.
After configuration please connect the modem to the MR00xFA/DL using the cable delivered
with the modem and plug it into the DSUB labelled with “MODEM”.