Please do the following settings:
Change
marked values
Browse for DS:
Select the de-
vice server
Then you can program the values for the serial communication after startup in the sheet “Default Serial Set-
tings” (baudrate, data bits, parity, flow control). A click at „OK“ generates the virtual port and then it can be
used in your M-Bus software. Please select the respective port (VSP name) in your software as the commu-
nication interface. Now the installation is completed. You can change the settings of the device and the COM
port using the DS manager respectively the VSP manager at any time. You can also change the settings of
the device server and check its routing state after first setup using a web browser connected to the assigned
IP address. The required password for the login is empty on delivery.
To Next Page
Loading...