Need help?Do you have a question about the Reliable Digital Steam Press and is the answer not in the manual?
Set the appliance on a sturdy work surface and unlock the locking knob before operation.
Ensure the appliance is unplugged, lift the plate, fill the tank with distilled water carefully.
Unlock the knob, lift the plate, plug in the appliance, and press the POWER button.
Use the SELECT arrow buttons to choose the fabric type and temperature setting.
Steam is produced when the Yellow Steam Ready light is on. Use Burst function when slightly opened.
Lift handle, arrange garment, lower plate to capture fabric, use steam burst for wrinkles if needed.
Turn off power, disconnect, cool down, lower plate, lock knob, wrap cord, and store unit upright.
Clean pressing plate with damp cloth after cooling. Ironing board cover is removable for washing.
Using a press cloth between fabric and plate is desirable, especially for delicate fabrics.
Take care with heat-sensitive items; lower heat, face items down, use press cloth before pressing.
Lightly spray garment with water before pressing to distribute a fine mist and remove wrinkles.
Place a damp cloth over stubborn/heavy fabrics, press briefly, lift plate, let steam escape, repeat.
Use cushion for darts, seams, or shaped garments. Place cushion under raised area, ensure only raised area contacts plate.
Place fabric behind board, pull forward, press section by section, allow pressed fabric to drape.
Steps for pressing shoulder yoke, sleeves, cuffs, body, side front, and collar of shirts/blouses.
Use cushion for waistband, inseam. Press front/back pleats, fold leg along crease, avoid pressing seams.
Use cushion for waistband. Fold pleats carefully and press each area until complete.
Embroidery face down, curtains end-to-end, dresses follow specific sections for best results.
To Next Page
General