CAUTION
• Never leave the steamer unattended when it's plugged in. Always
pull the plug out before you fill it with water.
• Never remove the tank locking cap while the steamer is running and
always check, before removing it, that no steam is coming out of the
gun.
• The tank-locking cap must be replaced with original spare parts. DO
NOT TIGHTEN THE CAP TOO MUCH AS IT WILL CAUSE THE
PLASTIC TO CRACK. MAKE SURE IT IS "SNUG".
• The use of normal tap water is recommended for the i500. In order
to clean the steam generator and remove mineral content, rinse it
internally (every 15-20 Liters of water used or every month) with tap
water.
• The guarantee does not cover mineral damages due to not rinsing
the steam generator.
• Service: If you need to have your i500 serviced, please contact only
authorized technical assistance centers (for further information
please call 800-268-1649 or visit our web site at
www.reliablecorporation.com).
IMPORTANT
When you are finished using the steamer for the day, unscrew the fill cap
one-turn on the unit to release the steam/air from the tank. This will eliminate
the vacuum that may cause damage to the pressure gauge.
TECHNICAL DATA
Full aluminium-plated heating element at 800W –120V
Boiler power i500: 1000W
Working pressure i500: 3,5 bar
Tank nominal capacity of model i500: 2,5 Litres
To Next Page
Loading...
