This is the safety-alert symbol. When you see this symbol on your equipment or in this manual, look for one
of the following signal words and be alert to the potential for personal injury or death.
WARNING
Warns about hazards that could cause serious personal injury or, death, and or major property
damage and if ignored presents a potential hazard.
CAUTION
Warns about hazards that will or can cause minor or moderate personal injury and/or property
damage and if ignored presents a potential hazard. It can also make consumers aware of actions that are
unpredictable and unsafe.
The NOTICE label indicates special instructions that are important but not related to hazards.
READ, UNDERSTAND, AND FOLLOW ALL SAFETY AND OPERATION INSTRUCTIONS.
FAILURE TO FOLLOW SAFETY AND OPERATION INSTRUCTIONS CAN RESULT IN SEVERE
PERSONAL INJURY OR DEATH.
CAUTION
To reduce risk of injury, do not permit children to use or climb on this product. Closely
supervise children at all times. The ANSI/NSPI-4 Standard (above-ground and on-ground pools)
advises that components such as the ltration system, pumps, and heaters be positioned to prevent
their being used as a means of access to the pool by young children.
WARNING
COMPONENT SEPARATION HAZARD
Pool and spa water circulation systems operate under hazardous pressure during start up, normal
operation, and possibly after pump shut off. Pressure in system can cause explosive component
separation of the upper lter body if safety and operation instructions are not followed. Severe personal
injury or death can result.
This product should be installed and serviced only by a qualied pool professional.
TO AVOID COMPONENT SEPARATION
• Follow all safety and operation instructions.
• Do not operate water circulation system if a system component is assembled improperly, damaged,
missing, or not a genuine component.
• Before performing maintenance on the water circulation system, verify all system and pump controls
are in OFF position and lter manual air relief valve is in the OPEN position.
• Use ONLY genuine components: Only use original components designed for this filter otherwise there
may be a risk of product failure and/or explosive separation of the filter.
• Never rely on hand tightening the clamp nut to the clamp bolt. Using a ¾” socket on a torque wrench,
torque clamp nut and clamp bolt to 150 inch-lbs.
• Before starting system pump, insure lter manual air relief valve body is in LOCK position in lter
upper body.
• Before starting the system pump, verify that all system valves are set in a position to allow water from
the lter to return back to the pool.
• Before starting the system pump, the manual air relief valve must be in the OPEN position.
• When starting pump, do not stand over or near lter.
• If water leakage appears in the area of the lter tank clamp, immediately turn off all system circulation
pumps and electrical power. Do not return to the lter until all water ow has stopped. Re-assemble
the clamp system per the instructions in this owner’s manual to stop the leak.
• Return to lter to close manual air relief valve only when a steady stream of water (Not air or air and
water mix) is discharged from the manual air relief valve.
• Do not change lter control valve position while system pump is running.
WARNING
EXCESS PRESSURE HAZARD
Pressure testing of the pump and lter system in excess of the 50 PSI can cause explosive separation
of the components. Component separation can result in severe personal injury or death.
To Next Page
Loading...