ENGLISH
Hold the watch head in your
right hand and the bracelet
clasp in your left hand.
Look on the inside of the
bracelet. The removable links
are marked with an arrow.
NOTE: Only the above arrow
pattern can be adjusted. Any
other pattern will be damaged
if attempted to adjust.
Identify the link you want to
remove. Hold that link between
the finger and thumb of your
right hand. Using your left
hand, fold the bracelet to a
90 degree angle.
Once the bracelet is separated,
slide the link to be removed
over into your right hand and
twist away from you as before.
The link is now removed.
To reattach the bracelet, hold
the links at a 90 degree angle
and push the bar on the right
link into the slot on the left
link. You should feel a click
when the link is attached.
Once the link is in place the
bracelet is ready to be worn.
Using your left hand twist
the link away from the bracelet
to remove. (The bracelet must
be at a 90 degree angle in
order for the link to separate).
This procedure should be followed carefully for each link that needs to be removed.
NOTE: Only the above styles can be adjusted with this process.
Adjust-A-Link - MEN’S
The Men’s Adjust-A-Link instructions work for the following watch styles only:
ZR11607 ZR15363
Adjust-A-Link - LADIES’
By removing extra links you can size bracelet to fit your wrist.
Lift tab at end of center section on last link.
Open clasp and remove link.
To Next Page
Need help?
General