RELM MS200 User Manual

Details the company's history and expertise in radio manufacturing.

Instructions for safely removing the unit from its packaging.

Guidance on connecting and using the AC adapter for power.

Steps to connect the provided telescopic or external antenna.

Instructions for installing the scanner in a vehicle.

Adjusts power and audio volume level for the scanner.

Eliminates background noise when no signal is received.

Used to manually select channels or characters during programming.

Port for connecting an external 12 VDC power source or adapter.

Connection point for the scanner's antenna.

Output for connecting an external speaker to the unit.

Provides audio output for connecting to a tape recorder.

DB-9 connector for computer-based programming of the unit.

Prevents accidental changes to the unit's programmed data.

Steps to enter desired frequencies and associated tone codes.

How to assign alphanumeric names to identify programmed channels.

How to enable and use the CTCSS/DCS tone decoding feature.

Instructions for setting the switch to prevent data changes.

Explains how to continuously monitor a single channel.

Procedure for removing a programmed channel from memory.

Basic operation of the scanning mode and channel selection.

Setting a delay time after an active frequency is found.

How to enable priority scanning for a designated channel.

Instructions for finding active frequencies within a band.

Setting the low and high frequency limits for searching.

How to scan for National Weather Service (NWS) broadcasts.

Enables priority channel sampling during WX Scan.

Activates the alert feature for severe weather tone warnings.