Need help?Do you have a question about the REMEHA Gas 350 and is the answer not in the manual?
Details water pressure testing procedure, including blanking connections and leak checks.
Lists specialized tools for boiler assembly; some available on loan.
Lists primary internal boiler sections and connecting parts.
Identifies components for water distribution, return, flow, and drainage.
Covers bolts, nuts, washers, rear radiation panels, and ceramic cords.
Details various panels forming the flue hood.
Lists components for mounting and assembling the instrument control panel.
Covers protection plates, control boxes, and cable management ties.
Includes supports for gas pipes and side panels of the casing.
Explains insulation panel sizing and cutting instructions for boiler sections.
Details connectors for the control box and gas multibloc.
Covers wiring for ignition valve and optional safety thermostats.
Describes wiring for optional water pressure, gas leak, and gas pressure sensors.
Instructions for installer to connect 230V mains power supply.
Details wiring for various capillary-based temperature sensors.
Instructions for handling and initial preparation of an assembled boiler from the pallet.
Guidance for starting assembly of a non-pre-assembled boiler.
To Next Page
General