GBDNLFEIDKSFINPSKCZPL
HUN
RUTRROGRSLAE
HR/
SRB
ENGLISH
GB
TO REPLACE THE FOIL
Pull the foil assembly up to remove from the hair pocket.
Insert new foil assembly in hair pocket until it snaps in place.
TO REPLACE THE CUTTERS
Grasp cutter between thumb and forefinger and pull upward.
Snap both new cutter assemblies into top of oscillator tips.
Spare Parts:
Replacement model F4790: SP-290
F5790: SP-390
F6790-F7790: SP-399
Note: Do not press on the cutter ends as this may cause damage.
IMPORTANT SAFETY INSTRUCTIONS
WARNING – TO REDUCE THE RISK OF BURNS, ELECTROCUTION, FIRE,
OR INJURY TO PERSONS:
An appliance should never be left unattended when plugged in to a power outlet, except
when charging. Keep the power adaptor and cord away from heated surfaces.
Make sure the power adaptor and cord do not get wet.
Do not plug or unplug the shaver with wet hands.
Do not use the product with a damaged cord. A replacement can be obtained via the
Remington
®
Service Center.
Charge, use and store the product at a temperature between 15°C and 35°C.
Always unplug from the mains when cleaning or when being used under running water.
Only use parts supplied or recommended by Remington
®
.
Keep this product out of reach of children. The use of this appliance by persons with
reduced physical, sensory or mental capabilities or lack of experience and knowledge can
give cause to hazards. Persons responsible for their safety should give explicit instructions
or supervise the use of the appliance.
090248_REM_IFU_F4790_5790_22L.indd 5 21:05:03|17.04.09 Guido Krölls
To Next Page
Loading...
