6
, STEP 1 - Nape of the Neck - DIAGRAM A
• Use setting 1 (6mm).
• Hold the clipper with the blade teeth pointing upwards. Begin starting at
the centre of the head at the base of the neck.
• Slowly lift the clipper, working upwards and outwards through the hair,
trimming just a little at a time.
, STEP 2 - Back of the Head - DIAGRAM B
• With setting 3 (12mm), cut the hair at the back of the head.
, STEP 3 - Side of the Head - DIAGRAM C
• With setting 1 (6mm), trim the sideburns. Then change to setting 2 (9mm)
and continue to cut to the top of the head.
, STEP 4 - Top of the Head - DIAGRAM D
• With setting 4 (15mm), cut hair on top of the head against the direction in
which the hair normally grows.
• For longer hair on top either use the 18mm attachment guide comb or use
without a guide comb.
• If using without a guide comb lift the hair on top of the head with a small
hand comb. Cut over the hand comb with the hair lifted or hold the hair
between the ngers to lift it and cut it to the desired length.
• Always work from the back of the head.
, STEP 5 - The Finishing Touches - DIAGRAM E, F & G
• Use the clipper without an attachment comb for close trimming around the
base and sides of the neck.
• To produce a clean straight line at the sideburns, reverse the hair clipper.
• Place the reversed clipper at right angles to the head, tips of the blades
lightly touching the skin and then work downwards.
C CARE FOR YOUR HAIRCLIPPER
• Your clipper is tted with high quality blades. To ensure long lasting
performance of your clipper, clean the blades and unit regularly.
, AFTER EACH USE
• Ensure the clipper is switched o and disconnected from the mains.
• Turn the clipper to the backside.
• Press both buttons located above the lock switch at the same time to open
the hair pocket (Diagram H).
ENGLISH
To Next Page
Loading...
