Remington HC366 - Maintenance and Troubleshooting; Six-Month Blade Maintenance; General Cleaning Cautions; Troubleshooting Common Issues

7
EVERY SIX MONTHS
• At regular intervals the blade set should be removed and cleaned.
• Remove the 2 screws retaining the xed blade with a screwdriver. Do not remove
blade set.
• Brush out hairs from between the blades with soft cleaning brush. Do not remove
the lubricating grease from the blades. It is not necessary to remove the small
moving blade from the unit.
• If the moving blade has been removed this can be re-tted by slotting the coated
blade holder over the pin in the centre of the interior product head. The groove on
the coated blade, just below the teeth, rests on a metal plate at the opposite side to
the screw holes. The xed blade is tted with the raised prole pointing outwards
and xed with the 2 screws.
• Before fully tightening the 2 screws, adjust the taper lever to the lower position and
align the blades so that their cutting edges are parallel to one another. Tighten the
2 screws.
• If the blades are not correctly aligned, cutting eciency will be impaired.
• Place a few drops of cutter or sewing machine oil onto the blades. Wipe o excess
oil.
CAUTION:
• Do not use liquid cleaners on the blades or harsh or corrosive chemicals on the
blade casing. Always use a soft brush to remove the accumulated hairs.
• Unplug the charge adaptor from the power outlet when tting or removing
attachments, or while cleaning the product.
• Always store this appliance and cord in a moisture-free area.
• Do not wrap the cord of the charging adaptor around the appliance.
TROUBLESHOOTING
If blades do not seem to cut hair easily, the taper lever can be used to remove any hair
caught between the comb and blade. Switch the clipper on and move the taper lever up
and down a few times but do not force the lever in either direction. This should remove
hairs and restore the cutting eciency.
If not, contact your nearest Remington® Service Centre.
CARE FOR YOUR TRIMMER
• Care for your product to ensure a long lasting performance. We recommend you
clean your trimmer after each use. The easiest and most hygienic way to clean the
trimmer is by rinsing the product head after use with warm water.
• Always keep the clipper in the o position when not in use.
AFTER EACH USE
• Rinse the accumulated hair from the cutters and shake o excess water.
• Wipe the main unit with a damp cloth and dry immediately.