ENGLISH
2
HOW TO USE
Before starting the cut
Inspect the clipper making sure that it is free from hair and dirt.
To attach a comb
Hold the comb with its teeth upward
Slide it onto and along the clipper blade until the front of the comb firmly sits against the
clipper blade.
To remove the comb
Holding the clipper with the blades facing away from you, firmly push the comb upward
and away from the blades.
Comb Attachments Hair
Lenghth
INSTRUCTIONS FOR HAIR CUTTING
STEP 1 – Nape of the neck – PICTURE 1
Use 3mm or 6mm guide comb.
Hold the clipper with the blade teeth pointing upwards. Begin starting at the centre of the
head at the base of the neck.
Slowly lift the clipper, working upwards and outwards through the hair, trimming just a
little at a time.
STEP 2 – Back of the head – PICTURE 2
With the 12 or 18mm guide comb attached, cut the hair at the back of the head.
STEP 3 – Side of the head – PICTURE 3
With the 3mm or 6mm guide comb attached, trim sideburns. Then change to the longer
12mm guide comb and continue to cut to the top of the head.
STEP 4 – Top of the head – PICTURE 4
With the 18mm, mm, mm guide comb attached, cut hair on top of the head
against the direction in which the hair normally grows.
For longer hair on top, use without a guide comb. Lift the hair on top of the head with a
small hand comb. Cut over the hand comb with the hair lifted or hold the hair between the
fingers to lift it and cut it to the desired length.
Always work from the back of the head.
.
15:00:06|05.05.09 Guido Krölls
ENGLISH
15
,
,
25
30
Each comb attachment is marked accordingly on its outside middle surface (3mm, 6mm, 9mm, 12mm,
15mm, 18mm, 22mm,25mm, 30mm).
0.5mm length is achieved without any combs.
To Next Page
Loading...
