Remington HC5150 - Cutting Hair Instructions; Nape of the Neck Cutting; Back of the Head Cutting

5
Comb Position Short Comb Long Comb
1 3mm 24mm
2 6mm 27mm
3 9mm 30mm
4 12mm 33mm
5 15mm 36mm
6 18mm 39mm
7 21mm 42mm
• 1mmlengthisachievedwithoutanycombs.
, TO ATTACH A COMB
• Holdthecombwithitsteethupward.
• Slideitontoandalongtheclipperbladeuntilthefrontofthecombrmly
sits against the clipper blade.
, TO REMOVE THE COMB
• Holdingtheclipperwiththebladesfacingawayfromyou,rmlypushthe
comb upward and away from the blades.
• Eachcombattachmentismarkedaccordinglyonitsoutsidemiddlesurface.
(3-21 mm & 24-42 mm)
, INSTRUCTIONS FOR CUTTING HAIR
• Forevencutting,allowthecombattachment/bladetocutitswaythrough
 thehair.Donotforceitthroughquickly.Ifyouarecuttingforthersttime,
start with the maximum comb attachment.
, STEP 1 – Nape of the neck
• Setthecombto3mmor6mm.
• Holdtheclipperwiththebladeteethpointingupwards.Beginstartingatthe
centre of the head at the base of the neck.
• Slowlylifttheclipper,workingupwardsandoutwardsthroughthehair,
trimming just a little at a time.
, STEP 2 – Back of the head
• Withthecombsetat12mmor18mm,cutthehairatthebackofthehead.
ENGLISH
GBDNLFEIDKSFINPSKCZ
HUN
PLRUTRROGRSL
AE HR
UA