Remington HC5200 ProPower - SHORT TAPERED STYLES - “FLAT TOPS & SHORT CUTS; CARE FOR YOUR HAIRCLIPPER; AFTER EACH USE; EVERY SIX MONTHS

6
, SHORT TAPERED STYLES – “FLAT TOPS” & SHORT CUTS
• Startingwiththelongestguidecombattached(24-42mm),cutfromtheback
of the neck to the crown. Hold the guide comb at against the head and slowly
move the clipper through the hair.
• Usethesameprocedurefromthelowersidetotheuppersideofthehead.Then
cut the hair against the direction in which it grows and level with the sides.
• Togivea“attop”look,thehairontopoftheheadmustbecutoverthetopofa
at comb.
• Useacloserguidecombtotaperthehairdowntothenecklineasdesired.
C CARE FOR YOUR HAIRCLIPPER
Yourclipperisttedwithhighqualityblades.Toensurelonglastingperformance
of your clipper, clean the blades and unit regularly. Always keep the attachment
guide comb on the trimmer blade.
, AFTER EACH USE
• Ensuretheclipperisswitchedoanddisconnectedfromthemainsbefore
cleaning.
• Brushtheaccumulatedhairfromtheblades.Donotsubmergetheclipperin
water.
• Tocleanunit,wipewithdampclothanddryimmediately.
, EVERY SIX MONTHS
• Atregularintervalsthebladesetshouldberemovedandcleaned.
• Removethe2screwsretainingthexedbladewithascrewdriver.Donot
remove blade set.
• Brushouthairsfrombetweenthebladeswithsoftcleaningbrush.Donot
remove the lubricating grease from the blades. It is not necessary to remove the
small moving blade from the unit.
• Ifthemovingbladehasbeenremovedthiscanbere-ttedbyslottingthe
coated blade holder over the pin in the centre of the interior product head. The
groove on the coated blade, just below the teeth, rests on a metal plate at the
 oppositesidetothescrewholes.Thexedbladeisttedwiththeraisedprole
 pointingoutwardsandxedwiththe2screws.
• Notethatifthebladesarenotcorrectlyalignedthencuttingeciencywillbe
impaired.
• Placeafewdropsofcutterorsewingmachineoilontotheblades.Wipeo
excess oil.
ENGLISH