5
ENGLISH
CHARGING YOUR APPLIANCE
It is recommended to fully charge your appliance before using it for the first time.
1. Ensure the product is switched off.
2. Connect the product to the USB cable and then to the USB end of the cable to a
powered USB port.
CHARGING INDICATOR LIGHT
Charging Fully charged Battery Low
The light will come on
The light will stay on for 5
minutes then go out
The light will flash for 5
seconds when there are 5
minutes or ledss of run
time left
• Your trimmer cannot be overcharged. However, if it is not going to be used for an
extended period of time (2-3 months), unplug it from the mains supply and store.
• To preserve the life of your batteries, let them run out every 6 months then recharge for
4 hours.
• Run time from fully charged is up to 40 mins.
ATTACHMENTS
TO FIT AND REMOVE ATTACHMENTS (FIG. B)
Ensure that the device is switched off before fitting or removing attachments.
• To remove, rotate the attachment anti-clockwise until it unlocks and then lift it off.
• To fit, place the desired attachment on top of the device and rotate the attachment
clockwise to lock it into place.
FITTING AND REMOVING STUBBLE GUIDE COMBS (FIG. C)
To Fit
• Hook the front of the comb over the blade.
• Press the back of the comb down until it clicks into place.
To Remove
• Lift the tab on the back of the comb upwards until it comes free from the blade.
INSTRUCTIONS FOR USE
Switch the product on by rotating the on-off switch to the I mark.
Always comb your beard or moustache with a fine comb before you start trimming.
GB
DE
NL
FR
ES
IT
DK
SE
NO
FI
PT
SK
CZ
PL
HU
RU
TR
RO
GR
SI
HR
RS
UA
BG
AE
To Next Page
Loading...
