ENGLISH
2
INSTRUCTIONS FOR USE
Before use, make sure hair is clean, dry and tangle-free.
Plug in the unit, press and hold the on-off switch until LCD’s light up.
For extra protection and best results, section hair prior to straightening and spray with
heat protection spray. Always straighten the lower layers first.
Run the straightener through the entire length of the hair, without stopping.
Repeat only twice per section to prevent hair damage.
IMPORTANT INSTRUCTIONS
Due to the extreme heat capabilities of this styler, extra care should be taken when using.
While heating and cooling, place on flat, smooth, heat-resistant surface. Only hold unit at
the end of the handle.
This is a high performance product, avoid frequent use to prevent damage to hair.
Please note regular use of styling products may deteriorate the coating.
Do not scratch the surface, as this will deteriorate the effectiveness of the coating.
CLEANING AND MAINTENANCE
Ensure the unit is unplugged and cool. To maintain the effectiveness of your product wipe
clean after use with a damp cloth. Do not use an abrasive cleaning fluid to clean, as damage
will occur.
SAFETY CAUTIONS
WARNING – FOR ADDITIONAL PROTECTION THE INSTALLATION
OF A RESIDUAL CURRENT DEVICE (RCD) WITH A RATED RESIDUAL
OPERATING CURRENT NOT EXCEEDING 30mA IS ADVISABLE. ASK AN
ELECTRICIAN FOR ADVICE.
WARNING – THIS APPLIANCE MUST NOT BE TAKEN INTO A BATHROOM.
IT SHOULD NOT BE USED NEAR BATHTUBS, SHOWERS, BASINS OR
OTHER VESSELS CONTAINING WATER OR OTHER LIQUIDS.
This product is not suitable for use in bath or shower.
090222 REM IFU S9810_UK.indd GB_2090222 REM IFU S9810_UK.indd GB_2 16.03.2009 21:36:09 Uhr16.03.2009 21:36:09 Uhr
To Next Page
Loading...
