EasyManua.ls Logo

Remington PG6000 - Charging Your Appliance; Charging Procedure; Charging Indicator Light; Attachments and Fittings

Remington PG6000
12 pages
Print Icon
To Next Page IconTo Next Page
To Next Page IconTo Next Page
To Previous Page IconTo Previous Page
To Previous Page IconTo Previous Page
Loading...
4
PARTS
1. On/O switch
2. Charging indicator light
3. Charging connector
4. Wide trimmer
5. Adjustable comb
6. Fixed guide combs
7. Precision trimmer
8. Nose, ear, eyebrow trimmer
9. Mini foil shaver
10. Deep cleansing brush head
11. Body hair trimmer
12. Body hair trimmer comb
13. Adaptor (not shown)
14. Storage pouch (not shown)
CHARGING YOUR APPLIANCE
Before using your trimmer for the rst time, charge for 4 hours.
1. Ensure the product is switched o.
2. Connect the charging adaptor to the product and then to the mains.
CHARGING INDICATOR LIGHT
Charge Level Indicator
Charging Blue LED will ash
Fully Charged Blue LED will light up continuously
Battery charge is low Red LED will ash
Your trimmer cannot be overcharged. However, if it is not going to be used for an
extended period of time (2-3 months), unplug it from the mains and store.
To preserve the life of your batteries, let them run out every 6 months then recharge
for 4 hours.
On a full charge, your beard trimmer will run for up to 90 minutes of cordless usage.
ATTACHMENTS
TO FIT AND REMOVE ATTACHMENTS FIG. A
Ensure that the device is switched o before tting or removing attachments.
To remove, rotate the attachment anti-clockwise until it unlocks and then lift it o.
To t, place the desired attachment on top of the device and rotate the attachment
clockwise to lock it into place.

Other manuals for Remington PG6000

Related product manuals